The post How to use NTP server? first appeared on Rubytech.

CLI command: (Suppose to create a new account/password “TESTER” with user privilege level 5, and the user only has permission to modify the System group settings. )

Switch# account

Switch(account)# add 5 TESTER TESTER

Switch(account)# exit

Switch# privilege

Switch(privilege)# group system 5

Note: For the example, all groups’ need to have higher privilege level than 5 except the “System” group.

The post Can I configure different users to login the switch which have different permission? first appeared on Rubytech.

The post I forget Username/Password for login? Is there any way to login the switch? first appeared on Rubytech.

The post Why my web UI display abnormal, but it looks fine on other PCs? first appeared on Rubytech.

Web UI path:

Security —> Access Management —> Configuration

CLI command: (Suppose only allow IP address 192.168.3.30~192.168.3.50 can access the switch by HTTP/HTTPS protocol .)

Switch# access

Switch(access)# add 1 ipv4 192.168.3.30 192.168.3.50 web

The post How do I restrict that the switch only can be accessed by specific IP address and protocol? first appeared on Rubytech.

Web UI path:

Maintenance —> Firmware —> Firmware Selection —> to press “Active Alternate Image” button.

CLI command:

Switch# firmware

Switch (firmware)# swap

The post How do I quick swap to the previous FW version if necessary? first appeared on Rubytech.

Every feature has it’s mapping help page , there are some basic explanation .

The post If we have some questions of specific function , any basic information we can get ? first appeared on Rubytech.

Switch# aggregation

Switch(aggregation)# group 1 1-2

Switch(aggregation)# sh

Aggregation Mode

—————-

Source MAC      : Enabled

Destination MAC : Disabled

IP Address      : Enabled

TCP/UDP Port    : Enabled

Group ID  Name    Type    Configured Ports  Aggregated Ports

——–  ——  ——  —————-  —————-

1         LLAG1   Static  1,2               None

Switch(aggregation)#

2. enable LACP : (aggregated port 3 and port 4)

Switch# lacp

Switch(lacp)# mode 3-4 enable

Switch(lacp)# sh config

Port  Mode      Key    Role

—-  ——–  —–  ——

1     Disabled  Auto   Active

2     Disabled  Auto   Active

3     Enabled   Auto   Active

4     Enabled   Auto   Active

5     Disabled  Auto   Active

6     Disabled  Auto   Active

7     Disabled  Auto   Active

8     Disabled  Auto   Active

9     Disabled  Auto   Active

10    Disabled  Auto   Active

Switch(lacp)#

The post How to increase bandwidth on this switch ? first appeared on Rubytech.

Setting it via Web :

Please configure syslog in the “Syslog —> Configuration” page , like below :

Server mode = enable

Server Address = 192.168.3.250 (server IP)

Syslog Level = Debug

U also can setting via CLI:

Switch(ip)#

Switch#syslog

Switch(syslog)# mode enable

Switch(syslog)# server 1 192.168.3.250

Switch(syslog)# level 7

Switch(syslog)# sh config

Server Mode      : Enabled

Server Address 1 : 192.168.3.250

Server Address 2 :

Syslog Level     : Debug

Switch(syslog)#

The post How to record all syslog of switch in some server ? first appeared on Rubytech.