The post Which UTP pairs are used for delivers power on ECO layer2 PoE managed series switches and web PoE series switches ? first appeared on Rubytech.

The post What kinds of UTP category agree with use on the switch ? first appeared on Rubytech.

The post How to do factory default on ECO layer2 managed series switches and web series switches ? first appeared on Rubytech.

Data : 8bit

Parity : none

Stop : 1 but

Flow control : none

The post What’s baud rate on the switch ? first appeared on Rubytech.

Configuration —> Filtering Data Base

And CLI command as below:

Switch# fdb

Switch (fdb)# show mac-table

No    Type     MAC Address        VID   Ports

—-  ——-  —————–  —-  —————

1     Dynamic  00-1a-80-4a-b8-e7  1     6

2     Static   00-40-c7-aa-bb-cc  1     None,CPU

3     Static   33-33-00-00-00-01  1     1-26,CPU

4     Static   33-33-00-00-00-02  1     1-26,CPU

5     Static   33-33-ff-17-38-fa  1     1-26,CPU

6     Static   33-33-ff-aa-bb-cc  1     1-26,CPU

Switch (fdb)# show static-mac

Total static MAC address : 0

The post How do I check the switch’s MAC table on web UI? first appeared on Rubytech.

Switch# reboot

The post How to warm boot via CLI ? first appeared on Rubytech.

Web UI

Telnet

SNMP

The post What kinds of managed interface does this switch support ? first appeared on Rubytech.