Which UTP pairs are used for delivers power on ECO layer2 PoE managed series switches and web PoE series switches ?

rubyadmin2016-01-28T18:35:08+08:00pins 1 and 2 (pair #2 inT568B ) and pins 3 and 6 (pair #3 in T568B)

What kinds of UTP category agree with use on the switch ?

rubyadmin2016-01-28T18:32:30+08:00Category 5.category 5e .category 6

How to do factory default on ECO layer2 managed series switches and web series switches ?

rubyadmin2016-01-28T18:31:53+08:00Stab /Push reset button until the front LED all flash, then release the button.

What’s baud rate on the switch ?

rubyadmin2016-01-28T18:25:04+08:00Baud rate : 115200 Data : 8bit Parity : none Stop : 1 but Flow control : none

How do I check the switch’s MAC table on web UI?

rubyadmin2016-01-28T18:17:55+08:00You can check it on web UI as the following path. Configuration ---> Filtering Data Base And CLI command as below: Switch# fdb Switch (fdb)# show mac-table No    Type     MAC Address        VID   Ports ----  -------  -----------------  ----  --------------- 1     Dynamic  00-1a-80-4a-b8-e7  1     6 2     Static   00-40-c7-aa-bb-cc  1     None,CPU 3     Static   33-33-00-00-00-01  1     1-26,CPU 4     Static   33-33-00-00-00-02  1     1-26,CPU 5     Static   33-33-ff-17-38-fa  1     1-26,CPU 6     Static   33-33-ff-aa-bb-cc  1     1-26,CPU Switch (fdb)# show static-mac Total static MAC address : 0

How to warm boot via CLI ?

rubyadmin2016-01-28T17:52:18+08:00Execute this command “reboot“ Switch# reboot

What kinds of managed interface does this switch support ?

rubyadmin2016-01-28T17:36:37+08:00CLI Web UI Telnet SNMP